en
Request a call Login / Registration
Menu
Selection assistant
Pit
Lift
3D
Classic Infrared
Computer Cabinet
Runout Compensation
Clear

News

all news
06/11/2019 Techno vector at the ProfiAuto Show in poland 8-9 of June 2019, equipment of the Techno Vector Group was represented at the ProfiAuto Show in Katowice (Poland)
05/31/2019 TECHNO VECTOR AT THE "AUTOPROMOTEC" EXHIBITION IN ITALY Since 22 to 26 of May 2019, the Techno Vector Group represented its equipment at the exhibition in Bologna.
03/15/2019 Techno Vector Group at the V international car industry forum TIAF Techno Vector Group took part in the V International Car Industry Forum TIAF supported by Automechanika 2019.

Certificates

all certificates

Techno Vector 7

7202 T 5 A

Series: Aluminum


How to Buy?

Description

Number of cameras 2 stationary cameras
Camera type 5 MPix machine vision industrial cameras, RAW
Mounting type Floor-mount. T-shaped pillar
Cabinet type Light-series (attached to the pillar)
Applicability Lift or Pit
Distance from cameras to the center of front turn tables 1500-2500mm, recommended distance 2200mm
Main advantages
  • 2-camera configuration is sufficient to organize a wheel alignment post on any pit;
  • Set of 5Mpix cameras allows a better use of the aligner on the lift*;
  • Does not need calibration and allows you to start working right after installation**.
* For lifts, the measurement height can be at approximately 900mm above the floor;
** Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement.

Installation and Calibration

Mounting Required (floor)
Calibration after mounting Not required*
* Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement.

Installation and calibration must be performed by a certified specialist.
This wheel aligner is supplied pre-calibrated and can be used right after installation.