Select Your Region:


all news
20.05.2024 TechnoVector at AutoServiceTec in Italy May 17th to 19th 2024 TechnoVector equipment was featured in Catania
28.03.2024 TechnoVector at DDOR BG Car Show & Motopassion On March 21-27, 2024 TechnoVector 8 contactless machine was featured in the trade show in Serbia
25.03.2024 TechnoVector and iPRO at AMTS 2024 On the 21-24th of March 2024 TechnoVector and iPRO equipment was featured at the show in Hungary.

TechnoVector 7

P 7204 TAS

Add to request
Product description

Premium Computer Cabinet

  • Ergonomic control panel
  • Recess for tablet* installation
  • Section for bar code reader* and tools
  • Comes with Full HD monitor

  • Easy access to printer* thanks to roll-out shelf
  • Pullout drawers for tools (622х383mm)
  • Brackets to store wheel adapters and targets

  • Bumper along the perimeter prevents the cabinet from damage when moving
  • Brackets for steering wheel holder and brake lock at the rear panel.

Main Advantages:

Number of cameras 4 stationary cameras
Type of cameras Industrial Grade HD high-precision optical RAW cameras
Type of mounting Mobile, T-type
Computer cabinet Mobile, P-cabinet
Applicability Lift
Distance from cameras to the center of front turn tables 2200 - 3000 mm
If installed at a distance of over 2200 mm from the front turn tables, the wheel aligner works from the lowest position (floor level) up to 1750mm.
Main advantages
  • The beam with cameras should be fastened on the top of the  pillar.
  • Mobile machine recommended for shops equipped with several wheel alignment posts.
  • Additional LED displays show prompts for technicians.


One of the advantages of this machine is that it can be used as a mobile or as a stationary version, as you prefer.
The pillar can be fastened to the cabinet on wheels to create a mobile model to move it between different wheel alignment posts, in case there are several of them.

On the other hand, the pillar can be mounted on the floor to remain immovable and the cabinet on wheels can be rolled around the shop.
All necessary spare parts are included in the set.

Extra displays show hints for technicians and can be useful when the monitor is obstructed by the lift or car

Light targets made of magnesium alloy are of a smaller size and can be used with magnetic clamps*** (if necessary)

*** - Magnetic clamps are not included in the base configuration and can be ordered separately.

Installation and Calibration

Installation Required
Calibration after installation   
Not required**
* Not included.
** Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement.

This wheel aligner is supplied pre-calibrated and can be used right after installation.
Installation and calibration must be performed by a certified specialist.

Comment type is not specified in the component properties.