+359 2 4444 909
News
all news
01/17/2020
Techno Vector at the «Automassan 2020» exhibition in Sweden
Techno Vector represents the equipment on the exhibition «Automassan 2020» in Goteborg from 15 to 18 January 2020.
10/08/2019
Techno Vector 8 at the exhibition «AUTO SALON and AUTOWEEK» in Korea
Contactless wheel aligner Techno Vector 8 at the exhibition «AUTO SALON and AUTOWEEK» on October 3-6, 2019.
10/01/2019
Techno Vector at the exhibition «AUTOTEC EXPO 2019» in Greece
27-29 of September 2019, Techno Vector equipment was represented at the AUTOTEC EXPO 2019 in Paianía (Greece)
Certificates
all certificates
Description
| Number of cameras | 2 stationary cameras |
| Camera type | 5 MPix machine vision industrial cameras, RAW |
| Mounting type | Floor-mount. T-shaped pillar |
| Cabinet type | T-series |
| Applicability | Lift or Pit |
| Distance from cameras to the center of front turn tables | 1500-2500mm, recommended distance 2200mm |
| Main advantages |
|
** Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement.
Installation and Calibration
| Mounting | Required (floor) |
| Calibration after mounting | Not required* |
Installation and calibration must be performed by a certified specialist.
This wheel aligner is supplied pre-calibrated and can be used right after installation.
Comment type is not specified in the component properties.