01/17/2020 Techno Vector at the «Automassan 2020» exhibition in Sweden Techno Vector represents the equipment on the exhibition «Automassan 2020» in Goteborg from 15 to 18 January 2020.
10/08/2019 Techno Vector 8 at the exhibition «AUTO SALON and AUTOWEEK» in Korea Contactless wheel aligner Techno Vector 8 at the exhibition «AUTO SALON and AUTOWEEK» on October 3-6, 2019.
10/01/2019 Techno Vector at the exhibition «AUTOTEC EXPO 2019» in Greece 27-29 of September 2019, Techno Vector equipment was represented at the AUTOTEC EXPO 2019 in Paianía (Greece)
|Number of cameras||2 stationary cameras|
|Camera type||5 MPix machine vision industrial cameras, RAW|
|Mounting type||Floor-mount. T-shaped pillar|
|Cabinet type||Light-series (attached to the pillar)|
|Applicability||Lift or Pit|
|Distance from cameras to the center of front turn tables||1500-2500mm, recommended distance 2200mm|
** Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement.
Installation and Calibration
|Calibration after mounting||Not required*|
Installation and calibration must be performed by a certified specialist.
This wheel aligner is supplied pre-calibrated and can be used right after installation.