YouTube FaceBook instagram
Select Your Region:
Menu

News

all news
11/10/2021 Techno Vector Group at «SEMA Show 2021» Techno Vector and iPRO equipment has been represented on November 2-5, 2021 at the international exhibition «SEMA» in Las Vegas
09/06/2021 Techno Vector Group at the exhibition "Interauto 2021" On August 24-27 Techno Vector represents its equipment at the "Interauto 2021"
11/01/2020 Techno Vector at the online exhibition «SEMA360» From 2nd to 6th of November 2020 Techno Vector represents its equipment online at the SEMA360

Certificates

all certificates

Techno Vector 7

T 7204 T A


How to Buy?
More about model
(0)
0 из 5 Оценок: 0.

Description

Number of cameras 4 stationary cameras
Camera type 2x1.3MPix and 2x5MPix machine vision industrial cameras, RAW
Mounting type Floor-mount. T-shaped pillar
Cabinet type T-series
Applicability Lift or Pit
Distance from cameras to the center of front turn tables 1200-2550mm, recommended distance 2200mm
Main advantages
  • Does not need calibration and allows you to start working right after installation*;
  • 4 camera configurations allow using a lift throughout all its height**.
* Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement.
** When installed at the distance of more than 2200mm from front turn tables, the wheel aligner works from the lowest position of the lift up to the height of 1700mm.

Installation and Calibration

Mounting Required (floor)
Calibration after mounting Not required*
* Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement.

Installation and calibration must be performed by a certified specialist.
This wheel aligner is supplied pre-calibrated and can be used right after installation.

Comment type is not specified in the component properties.



The product ID is required.