en
Request a call Login / Registration
Menu
Selection assistant
Pit
Lift
3D
Classic Infrared
Computer Cabinet
Runout Compensation
Clear

News

all news
11/01/2018 Techno Vector equipment at the SEMA show Techno Vector equipment at the SEMA show in Las Vegas (USA) on October 30 - November 2, 2018.
10/23/2018 Techno Vector 8 SMARTLIGHT at Auto Week 2018 The annual international show Auto Week 2018 took place in Seoul (South Korea) on October 19th to 21st, 2018.
10/16/2018 Techno Vector equipment at AUTOTECH 2018 trade show Techno Vector Equipment at AUTOTECH 2018 trade show in Plovdiv (Bulgaria), September 24-29

Certificates

all certificates

Techno Vector 7

V 7202 T 5 A

Series: Aluminum


How to Buy?

Description

Number of cameras 2 stationary cameras
Camera type 5 MPix machine vision industrial cameras, RAW
Mounting type Floor-mount. T-shaped pillar
Cabinet type V-series
Applicability Lift or Pit
Distance from cameras to the center of front turn tables 1500-2500mm, recommended distance 2200mm
Main advantages
  • 2-camera configuration is sufficient to organize a wheel alignment post on any pit;
  • Set of 5Mpix cameras allows a better use of the aligner on the lift*;
  • Does not need calibration and allows you to start working right after installation**.
* For lifts, the measurement height can be at approximately 900mm above the floor;
** Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement.

Installation and Calibration

Mounting Required (floor)
Calibration after mounting Not required*
* Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement.

Installation and calibration must be performed by a certified specialist.
This wheel aligner is supplied pre-calibrated and can be used right after installation.