News
all news
09.12.2024
TechnoVector and iPRO Equipment at Automechanika Shanghai 2024
On December 2-5, 2024 TechnoVector showed its wheel alignment equipment at Automechanika Shanghai 2024 in China.
16.09.2024
TechnoVector at Automechanika 2024
On September 10-14, 2024 TechnoVector equipment was featured at the show in Germany
20.05.2024
TechnoVector at AutoServiceTec in Italy
May 17th to 19th 2024 TechnoVector equipment was featured in Catania
Product description
Description:
Number of cameras | 5 movable cameras |
Сamera type | Industrial Grade HD high-precision optical RAW cameras |
Mounting type | Floor-mount. Two low pillars. |
Cabinet type | V - series |
Applicability | Pit |
Distance from cameras to the center of front turn tables | 2000 - 3500 mm * |
Main advantages |
|
|
* If it is necessary to measure control points of the frame near the front bumper, the distance from the cameras to the front turn tables should be not less than 3000mm. |
INSTALLATION AND CALIBRATION
TechnoVector 7204 HT MC wheel aligner is shipped completely calibrated. Installation is not required. The calibration should be performed only if parts of the wheel aligner were damaged and/or skewed.
Transportation of the device must be carried out in special package in enclosed means of transportation (enclosed freight cars, enclosed car bodies, holds, hermetically sealed compartments of aircraft).
When transported boxes with the devices must be rigidly fastened to the means of transportation. Rules of cargo handling must be followed according to the signs on the box: Fragile, This Side Up, Handle with Care, Keep Dry.
Comment type is not specified in the component properties.