News
all news
09.12.2024
TechnoVector and iPRO Equipment at Automechanika Shanghai 2024
On December 2-5, 2024 TechnoVector showed its wheel alignment equipment at Automechanika Shanghai 2024 in China.
16.09.2024
TechnoVector at Automechanika 2024
On September 10-14, 2024 TechnoVector equipment was featured at the show in Germany
20.05.2024
TechnoVector at AutoServiceTec in Italy
May 17th to 19th 2024 TechnoVector equipment was featured in Catania
Product description
Premium Computer Cabinet
- Ergonomic control panel
- Recess for tablet* installation
- Section for bar code reader* and tools
- Comes with Full HD monitor
- Easy access to printer* thanks to roll-out shelf
- Pullout drawers for tools (622х383mm)
- Brackets to store wheel adapters and targets
- Bumper along the perimeter prevents the cabinet from damage when moving
- Brackets for steering wheel holder and brake lock at the rear panel.
Main Advantages:
Number of cameras | 4 stationary cameras |
Type of cameras | Industrial Grade HD high-precision optical RAW cameras |
Type of mounting | Floor-mount. Two pillars |
Computer cabinet | Mobile, P-cabinet |
Applicability | Lift |
Distance from cameras to the center of front turn tables |
2200 - 3000 mm If installed at a distance of over 2200 mm from the front turn tables, the wheel aligner works from the lowest position (floor level) up to 1750mm. |
Main advantages |
|
Features
Extra displays show hints for technicians and can be useful when the monitor is obstructed by the lift or car

Light targets made of magnesium alloy are of a smaller size and can be used with magnetic clamps*** (if necessary)
*** - Magnetic clamps are not included in the base configuration and can be ordered separately.
Installation and Calibration
Installation | Required |
Calibration after installation |
Not required** |
** Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement.
This wheel aligner is supplied pre-calibrated and can be used right after installation.
Installation and calibration must be performed by a certified specialist.
Comment type is not specified in the component properties.